Skedbooks
←
Automobile Engineering

Initial Vehicle Inspection

Introduction:

The initial vehicle inspection is not a checklist. Systems with a fixed orifice valve and cycle switch (CCOT) are controlled mainly by pressure measurement. This means that pressure type tests like cycle tests are well suited to diagnosing system faults. Systems like TXV which are controlled by measuring temperature are well suited to all gauge and temperature tests.

Simple inspection routine

CHECK CONDENSER FINS FOR BLOCKAGE OR DAMAGE

  • If the fins are clogged, wash them with water.

Note – be careful not to damage the fins.

CHECK THE POLLEN FILTER FOR SERVICE CONDITION

  •  If dirty remove and replace.

MAKE SURE THAT DRIVE BELT IS INSTALLED CORRECTLY

  •  Check that the drive belt fins fit properly in the ribbed grooves.

CHECK DRIVE BELT TENSION

  •  Check the drive belt tension.

CHECK CONDENSER FAN FREELY ROTATES

Note – after installing the drive belt, check that it fits properly in the ribbed grooves.

CHECK ENGINE COOLANT LEVEL

  • Check coolant level. If unsatisfactory then test coolant system.

START ENGINE AND TURN ON A/C SWITCH

  •  Check that the A/C operates at each position of the blower switch. If blower does not operate, check electrical circuits.

CHECK MAGNETIC CLUTCH OPERATION

  •  If magnetic clutch does not engage, check system pressure with gauges and power supply and operation of A/C control, e.g. electrical operation of low pressure switch.

CHECK THAT IDLE INCREASES

  •  When the magnetic clutch engages, engine rpm should increase.
  •  Standard idle-up rpm: 900–1000 rpm.

CHECK THAT CONDENSER FAN MOTOR CUTS IN

CHECK THAT THE HEATING PIPES LEADING TO THE HEAT EXCHANGER ARE HOT

CHECK THE PERFORMANCE OF THE A/C CONTROLS

  •  Check the air distribution control, vary the direction of the air distribution and check air flow. Vary air temperature to test blend operation. Use a temperature probe to verify temperature range (4–60°C) and air direction (panel, floor, face).

The initial vehicle inspection should direct the technician to one of the following:

1. A performance diagnostic test on the A/C operation:

  •  A/C performance test
  •  Pressure gauge analysis
  •  Temperature measurement on A/C components
  •  Refrigerant identification test
  •  Level of refrigerant charge
  •  Recovery
  •  Leak testing – OFN, bubble, vacuum, UV dye.
  •  Recharge and retest

2. A/C electrical tests:

  •  Self-test checking for fault codes via control panel LCD/graphics display.
  •  Serial test using a handheld tester – wiggle test, actuator, DTC, data logger.
  •  In-depth ‘pin-by-pin’ electrical test using a break-out box or directly from the module connector.

Information from the customer on the symptoms, vehicle history and conditions upon which the fault occurs will allow the technician to be selective. The technician should first try to gather as much information as possible and assess if the symptom is normal behaviour (water dripping from underneath the vehicle) or not. The technician should then assess if the environment in which the fault occurs can be replicated.